This is a design for DC to DC converter module. The module is a device that accepts a DC input voltage and produces a DC output voltage. Normally the output voltage produced is at a different voltage level than the input. DC to DC converters are used to provide noise isolation as well as power bus regulation. In this circuit, converter is using LTM4600. Look to the figure of the circuit.
The 10A High efficiency DC/DC converter module LTM4600 is a complete 10A, DC/DC step down power supply. Included in the package are the switching controller, power FETs, inductor, and all support components. Operating over an input voltage range of 4.5V to 20V, the LTM4600 supports an output voltage range of 0.6V to 5V, set by a single resistor. This high efficiency design delivers 10A continuous current, needing no heat sinks or air flow to meet power specification. Only bulk input and output capacitors are needed to finish the design.
The 10A High efficiency DC/DC converter module LTM4600 is a complete 10A, DC/DC step down power supply. Included in the package are the switching controller, power FETs, inductor, and all support components. Operating over an input voltage range of 4.5V to 20V, the LTM4600 supports an output voltage range of 0.6V to 5V, set by a single resistor. This high efficiency design delivers 10A continuous current, needing no heat sinks or air flow to meet power specification. Only bulk input and output capacitors are needed to finish the design.
