This is a design circuit for a simple zone alarm circuit. This circuit has features automatic Exit and Entry delay and a timed Bell / Siren Cut-Off. This circuit is work with controlled by IC 4011. This circuit is easy to built and used. This is the figure of the circuit.
The operation of the circuit is begin when, first, check whether buildings are safe and green LED lights. Then move SW1 to the “set” position. Red LED will light up. You now have about 30 seconds to leave the building. When you go back and open the door – the Buzzer will sound. You then have about 30 seconds to move SW1 to the “off” position. If you fail to do so – the relay will energize and the Siren will sound. While at least one of the switches in the closed loop is usually kept open – the Siren will continue to be heard. However, about 15-minutes after the loop has been restored – the relay will de-energy – the Siren will Cut-off – and the alarm will reset. Of course, you can turn the Siren off at any time by moving SW1 to the “off” position. Because of manufacturing tolerances – the right length of the delay depends on the characteristics of the actual components you’ve used in the circuit. But by changing the values of R3, R6 & R9 you can adjust the Exit, Entry and Bell Cut-off times to suit your needs. Increasing the values increases the time – and vice versa.
